Topcon LS-80X Laser Receiver with Holder 6 Receiver Clamp

Product Description

Topcon LS-80X Laser Receiver with Holder 6 Receiver Clamp

p/n: 1046259-01

The Topcon LS-80X Laser Receiver Sensor Detector is able to allow you to have a longer range when using a red beam rotary laser. The unit can be adjusted for either a fine or course band, which will help improve the accuracy. It has an audible notice for the height, to make sure it is adjusted properly The Newly improved LS-80X has a rear mounted speaker with a louder setting for a louder audible tone on noisy jobsites where the audible tone is hard to hear. You can select from 11 different channels to display the data on the LCD display.

With a rating of IP-66, the Topcon LS-80X Laser Receiver Sensor Detector is protected against dust and water. The unit is in a rubber case, so it is also protected against dropping it. It will stand up to a variety of job conditions. It can also be mounted with a Holder 6 bracket, so it will be more stable.

The Topcon LS-80X Laser Receiver Sensor Detector runs on two AA batteries. It will run for up to 120 hours, allowing for plenty of work time on the job site. It will also shut down after 30 minutes if it hasn’t been used, to help save the battery life.

Topcon LS-80X / 1046259-01 Receiver SPECIFICATIONS

• Working Diameter 3 to 3,100 feet
• Defective Precision High Precision +/- 1.0mm
• Normal Precision +/- 2.0mm
• Detective Range 50mm
• Dual LCD (Both Sides)
• Arrow Display: 9
• Numeric Readout: N/A
• Speaker Levels: Loud/Low/Off
• Warning Display
  • Height Alert
  • Battery Level
• Auto Shutoff: 30min
• IP Rating: IP66
• Operating Temperature: -20 to +50C
• Dimensions: 146 (L) x 76 (W) x 25 (H) mm
• Power Supply: 2x AA Dry CELL or Alkaline
• Battery Life: 120h (Alkaline)

PLUS

Topcon Holder 6 Receiver Clamp

pn ; 312890112

The Topcon Sensor Holder 6 is designed to hold the Topcon LS-80 and LS-70 laser receivers. The clamp holds the receiver securely, so you do not have to worry about it getting damaged. It can then be mounted to a tripod or other wide surface, to keep it where you need it. It also works to being attached to a levelling staff. The static thread keeps the side of the clamp from being in the way. It is strong and lightweight, making it sturdy enough for the job site.

The Topcon Holder 6 laser receiver bracket works with the following laser receivers:

• Topcon LS-80A laser receiver (57140)
• Topcon LS-80B laser receiver (57131)
• Topcon LS-80G laser receiver (57149)
• Topcon LS-80L laser receiver (57181)
• Topcon LS-B10 machine control laser receiver (57110)